YILMAZ PCC 6505 User Manual page 121

7. OPERATION
 Click on
 Click on
 Click on
 First, set the axis as home.
.
 Lower the Robot Z axis using
Follow the following steps;
 Calibration of the robot Y axis must be done through the following screen

write the same value in Set position
button on the same screen.
button and enter the required password. (5678)
button.
Write any measurement in "Hedef nokta (Target point)" field;
button, you will send the robot to the measurement on Y axis.
buttons until it is aligned with any spool.
field as well; by clicking on
119