7. OPERATION
same value in
button
saw as shown in the picture below
If 90 degree is correct, you do not need calibrate. If it is not correct, for example if you measured as 89
degree, then write 89 in "hedef nokta (target point)" field and click on calibrate
button.
7.6.4. Robot Profile Holding Y Calibration:
Click on
pressing
On the above menu, write 90 in
Take the 90-degree caliber apparatus and insert it between the miter and the
button when in the cutting screen from the list.
button on the robot jaw control menu.
field; then click on
Move the robot jaw to the horizontal position by
118
field and write the