YILMAZ PCC 6505 User Manual page 115

7. OPERATION

The desired length to be cut is written in this field. Welding margin should be added to the
cutting length for Pvc profile.

It indicates to which part of the carrier car the cut profile will be placed.

 If the part has been cut, it will display "1", otherwise "0".

The cutting height of the profiles is entered in this field.

The cutting width of the profiles is entered in this field.

The profile information on the Y axis while the robot holds the profile is entered here.
This measure varies according to the profile used.

The information of the position the robot will have on the Z axis while going to hold the
profile will be entered here. This measure varies according to the profile used.

Information about how many cycles should be repeated is entered in this field. For
example, if it is desired to restart the cycle after the last part has been cut, "1 " should be entered in
this field; the number of the cycles can be set by entering the desired number of cycles in this field.
The information on the angles of the cut is entered in this field.
113