Sending The Machine To The Reference Point - YILMAZ PCC 6505 User Manual

7. OPERATION

If it is wanted to use different lists other than the existing list, the changes can be saved
with different names and then used as needed.

This button should be pressed after the changes are made.

The operation is reset. The cut list must be run from the beginning.
7.4.3. Database Mode:
Database cutting mode. It uses the data obtained from optimization programs.
The machine cut list must be a * .mdb file. What should be written in which column is described in detail
below. The main title names of the columns must not be changed, otherwise the operation cannot be done.
Entering Saw Data:
7.4.4
 Click on
button when on list menu. Manuel operation page will open. On the opening window;

in this field.

profile is written in this field. At the same time, the saw waits over the profile after cutting for the period
specified in this field.

7.5. Sending The Machine To The Reference Point

 Click on
button when on the cutting menu from the list.
 Click on
button and enter the required password (5678),
 Click on
button.
This screen is divided into axes. Click on
home.
The relevant button should be clicked on to make the saw to set the Z axis as home.
Enter the thickness of the saw connected
How long the saw will wait over the
button in the menu of the axis you would like to set as
114