YILMAZ PCC 6505 User Manual page 119

7. OPERATION
write the same value in "Set position(hedefi seç)"
clicking on
For example; assuming you write 200mm, if the distance you measured between the
lower point of the saw and the table floor is equal to the value you have entered, then
you do not need calibrate. If not, write 201 mm in
7.6.3. Saw Angle Calibration:
 Click on
 Click on
 Click on
 First, set the axis as home.
 Lower the saw in order the miter to be adjusted to be placed using
Z control menu.
Follow the following steps;

Button, you will send the saw to the measurement on Z axis.
button.
button when on the cutting menu from the list.
button and enter the required password (5678).
button.
Write any measurement in "Hedef nokta(Target point)" field;
117
field as well; by
field and click on
buttons from saw