Table of Contents
Advertisement
9.2.4
Flash Programming Command Buttons
There are six flash-programming command buttons:
•
Program Sequence that executes erase, program, and verify commands in sequence
•
Ssig Chk that checks and shows the device's silicon signature
•
Blank Chk that checks whether the device is Blank (erased) or Not Blank (programmed)
•
Write that programs the selected user program file into flash memory
•
Erase that erases the flash device's memory
•
Verify that compares the user program file to the contents of the flash device's memory
9.2.4.1
Program Sequence
Clicking the Program Sequence command button causes the program to
1.
Power up and initialize the device, and then check the signature against the .PRC file
2.
Run a Blank Check to determine whether the device needs to be erased before
programming
3.
Executes an Erase operation if the device needs to be erased
4.
Performs a Write operation to program the device with the selected file
5.
Finishes with a Verify operation to check programming after the device is written
During the Program Sequence, the Status window displays the operation being performed and its
progress. At the end of the sequence, the Status window should show "Written and verified".
55
M-Station Baseboard
Advertisement
Table of Contents
