Table of Contents
Advertisement
8.6
OK, CANCEL, HELP Command Buttons
•
The OK command button closes the OPTMST program and writes the options for flash
programming into the system registry.
•
The CANCEL command button closes the OPTMST program without making changes to
the flash programming options in the system registry.
•
The HELP command button currently shows the version, date, and copyright information for
the OPTMST program.
9. FP4MST PROGRAM: M-STATION FLASH PROGRAMMING
The FP4MST (Flash Programming For M-Station) application allows the M-Station to be used to flash
program NEC Electronics 78K0 and 78K0S flash-programmable MCUs on micro-boards or target
systems. Refer to section 3 for information about configuring the M-Station and micro-board for flash
programming, and to section 8 about using OPTMST to set flash-programming options.
9.1
Starting FP4MST, Selection of PRC file
Start the FP4MST program by clicking its shortcut in the Start menu. The FP4MST – Select Flash
Device PRC File box lists a directory and its .PRC files. If this is the first time you have run FP4MST,
the box shows the directory where FP4MST was installed (default is C:\NECTools32\BIN) and there
may not be any .PRC files to list.
51
M-Station Baseboard
Advertisement
Table of Contents
