Help Command Button; Close Command Button - Renesas M-Station User Manual

Baseboard for 78k0 and 78k0s micro-boards

Table of Contents

When you click OK to close the FP4MST Flash Configuration box, the flash device is initialized and

its silicon signature read. If you change parameters that cause initialization to fail, such as changing

the communication port without changing necessary jumpers, you will receive a message and have the

opportunity to revise the configuration.

When changing the configuration from inside the FP4MST program, you should only change the

communication rate (to try higher SIO or UART communication rates) or set the .PRC file to be

automatically loaded.

9.4

Help Command Button

Clicking the Help command button displays the program name, version, date and copyright of the

FP4MST program.

9.5

Clicking the Close button exits the FP4MST program, reapplies V

releases the RESET line, allowing the user program to run on the device.

power to the flash device, and

M-Station Baseboard

Table of Contents