Table of Contents
Advertisement
M-Station Baseboard
•
Device name in signature and .PRC file do not match. If the M-Station can initialize the
flash device, and read the signature, and the signature matches the .PRC file except for the
device name, the following message is shown:
In this case, you may have selected a .PRC file for a device that is closely related to the one
you want to use. You should probably select "No" to not use this .PRC file, and then select
"Yes" to select a different .PRC file.
•
Cannot initialize flash device: If the M-Station can supply power, but the target device
does not initialize, you will see an error message such as this:
There are several possible problems:
Please recheck these items, and attempt to initialize the device again. For NEC Electronics
micro-boards, please try the configuration suggested in the appropriate appendix.
⎯ Jumpers selecting flash programming interface incorrect on M-Station (JP8 and JP9)
⎯ Jumpers selecting flash programming interface incorrect on micro-board
⎯ Option for flash clock set incorrectly in OPTMST
⎯ Frequency for clock set incorrectly in OPTMST
⎯ Option for Flash Programming communication channel set incorrectly in OPTMST
⎯ If using an FA-type adapter to program a loose device:
No device inserted
No clock driven on M-Station J7
Clock selection not set to "Host" in OPTMST
70
Advertisement
Table of Contents
