Character Sets - Intermec EasyCoder E4 Programmer's Reference Manual

Character Set, Fonts, and Bar Codes

1. Character Sets

Note:
The Euro currency sign (€)
is included in most single-
byte character sets, see Chap-
ter 6.11.
EasyCoder E4 Direct Protocol v2.10 – Programmer's Reference Manual
This chapter contains the various single-byte character sets, that
can be selected using the NASC statement. Double-byte character
sets are not included, but are available separately on special
request.
The following information applies to all single-byte character sets:
• Characters between ASCII 0 decimal and ASCII 31 decimal
are unprintable control characters as listed below.
• Characters between ASCII 32 decimal and ASCII 127 deci-
mal can always be printed, regardless of 7-bit or 8-bit com-
munication protocol, provided that the selected font contains
the characters in question.
• Characters between ASCII 127 decimal and ASCII 255 deci-
mal can only be printed if the selected font contains the
characters in question and an 8-bit communication protocol is
used. If you use 7-bit communication, select another national
character set (see NASC statement in Chapter 6.11) or use a
MAP statement to remap a character set (see Chapter 6.10).
• If a character, which does not exist in the selected font, is used,
a space will be substituted in a Speedo font, and an empty
rectangle in a TrueType font.
Non-printable control characters (ASCII 00-31 dec)
00 NUL
01 SOH
02 STX
03 ETX
04 EOT
05 ENQ
06 ACK
07 BEL
08 BS
09 HT
10 LF
11 VT
12 FF
13 CR
14 SO
15 SI
Chapter 11
16 DLE
17 DC1
18 DC2
19 DC3
20 DC4
21 NAK
22 SYN
23 ETB
24 CAN
25 EM
26 SUB
27 ESC
28 FS
29 GS
30 RS
31 US
79