Intermec EasyCoder E4 Programmer's Reference Manual page 64

Chapter 6 Setting Up the Printer
17. Printer Setup, cont.
62
Communication buffers
There are no setup parameters for setting the size of the input and
output buffers of the serial channel "uart:". There are 16 buffers,
each with a size of 492 bytes. These are shared between the input
and output processes.
Hence, if verbosity is disabled (SYSVAR(18)=0, see Chapter
6.13), the input capacity is maximised.
Setup fi les
Two commands are used to set a printer up from a setup fi le:
SETUP WRITE and SETUP.
Use a setup string (as described above) to set up the printer. Then
use the SETUP WRITE command to save the current printer
setup to a fi le.
SETUP WRITE "<fi lename>"
<fi lename>
You can then select the stored setup fi le, using the SETUP
command.
SETUP "<fi lename>"
<fi lename>
Examples:
SETUP WRITE "setup1" ↵
SETUP "setup3" ↵
Bar Code Wand
Setting up the printer with the Bar Code Wand does not involve
using Intermec Direct Protocol.
See the EasyCoder E4 User's Guides for details on using the Bar
Code Wand to set up the printer.
EasyCoder E4 Direct Protocol v2.10 – Programmer's Reference Manual
the full name of the setup fi le, including
storage area, enclosed by double quotation
marks.
the full name of the setup fi le, including
storage area, enclosed by double quotation
marks.