Label Taken Sensor - Intermec EasyCoder E4 Programmer's Reference Manual

6. Counters, cont.

7. Label Taken Sensor

8. Feed Button
EasyCoder E4 Direct Protocol v2.10 – Programmer's Reference Manual
Incrementation/Decrementation
COUNT& "INC", <counter number>,"<incr. value>|<decr. value>"
<incr. value>
<decr. value>
Default:
Stop Value
COUNT& "STOP", <counter number>,"<stop value>"
<stop value>
Default:
Restart Value
COUNT& "RESTART", <counter number>,"<restart value>"
<restart value>
Default:
All EasyCoder E4 printers are fi tted with a label taken sensor
(LTS) which detects if there is a label left in the printer's outfeed
slot and holds the printing until the label has been removed. This
facility is especially useful for batch printing.
You can enable or disable this function by means of the following
command. The setting is saved in the printer's fl ash memory.
LTS& ON | OFF
Default:
The <Feed> button on the EasyCoder E4 front panel is used to
initiate a PRINTFEED operation. You can enable or disable this
function. The setting is saved in the printer's fl ash memory.
PRINT KEY ON | OFF
Default:
Chapter 6 Setting Up the Printer
sets the value by which the counter should
be incremented.
sets the value by which the counter should be
decremented. Decrementation is indicated
by a leading minus sign (-).
1
sets the value after which the counter should
start all over again at the RESTART value.
2, 147, 483, 647 or Z
sets the value at which the counter should
start all over again after having exceeded the
STOP value.
1 or A
LTS& OFF
PRINT KEY OFF
53