Intermec EasyCoder E4 Programmer's Reference Manual page 61

15. Error Handling, cont.
Note that error handling and
error messages specifi ed by
ERROR commands are not
saved in the printer's battery
backed-up memory, but must
be transmitted to the printer
after each power-up.
EasyCoder E4 Direct Protocol v2.10 – Programmer's Reference Manual
Six error conditions are always handled without having to be
activated by an ERROR command. The Power LED switches to
red and the printer sends a message back to the computer on
the serial channel:
• 1005 Out of paper
The printer waits for the printhead to be lifted and lowered,
then the error is cancelled.
• 1022 Head lifted
The printer waits for the printhead to be lowered, then a
formfeed is performed. If the error stopped a print operation,
the operation will be restarted automatically.
• 1027 Out of transfer ribbon (thermal transfer printing only)
The printer waits for a ribbon to be loaded. If the error
stopped a print operation, the operation must be restarted.
• 1058 Transfer Ribbon fi tted (direct thermal printing only)
The printer waits for the ribbon to be removed. To clear the
error condition and go on, press the <Feed> button.
• 1059 Cutter does not respond (paper jam in cutter)
The printer waits for the paper jam to be cleared. To clear the
error condition and go on, press the <Feed> button.
• 37 Cutter device not found (cutter not connected)
The printer waits for a cutter to be connected. To clear the
error condition and go on, press the <Feed> button.
Chapter 6 Setting Up the Printer
59