Setting The Lss Threshold; Enabling/Disabling Automatic Cutting - Intermec EasyCoder E4 Programmer's Reference Manual

18. Setting the LSS Threshold

19. Enabling/Disabling Automatic Cutting

EasyCoder E4 Direct Protocol v2.10 – Programmer's Reference Manual
The sensitivity of the LSS ( Label Stop Sensor) can be manually
adjusted to detect gaps or black marks properly. Another way to
do this is to issue a TESTFEED command, but that involves
feeding out labels, which may be undesired in some cases.
The detection range is 0-31. Increase the value to make the LSS
more sensitive and vice versa. The present threshold value will
be returned on the serial channel using the instruction PRINT
SYSVAR(8), also see Chapter 7.6.
SYSVAR (8) = <threshold value>
<threshold value>
The standard EasyCoder E4 printers can optionally be fi tted with
a paper cutter that can cut non-adhesive paper strip or the liner
between labels (no cutter is presently available for the EasyCoder
E4 LinerLess model).
As an alternative to issuing separate CUT instructions (see Chap-
ter 5.1), you can enable or disable automatic cutting in connec-
tion with each PRINTFEED operation. By default, automatic
cutting is disabled.
The amount of media to be fed out before automatic cutting and
be pulled back afterwards can optionally be specifi ed:
CUT [<feed length>] ON | OFF
<feed length>
The CUT ON|OFF setting is saved in the non-volatile fl ash
memory and will therefore remain in effect even after a power
off or reboot.
Chapter 6 Setting Up the Printer
is an integer in the range of 0-31.
is the desired length in dots.
63