Intermec EasyCoder E4 Programmer's Reference Manual page 21

2. General Formatting Commands, cont.
EasyCoder E4 Direct Protocol v2.10 – Programmer's Reference Manual
Alignment
Once the insertion point is specifi ed, you must also decide which
part of the object should match the insertion point. For example,
a text fi eld forms a rectangle. There are 8 anchor points along
the borders and one in the center, numbered 1–9 as shown in
this illustration. The desired anchor point is specifi ed using the
ALIGN command.
ALIGN | AN <anchor point>
<anchor point>
Default value:
Reset to default by:
Example:
AN 1 ↵
ALIGN|AN will place the lower left corner of the text fi eld at
the insertion point specifi ed by PRPOS. Refer to the illustration
below for detailed information on the anchor points for various
types of printable objects.
Chapter 4
is a number from 1 – 9
1
PRINTFEED|PF
Label Design
19