Javad JNSGyro-4T Operator's Manual page 40

C O N F I G U R A T I O N
2
JNSGyro-4T Configuration
Click OK to close the Receiver Configuration screen.
6.
Click on File->Disconnect, and then File->Exit to quit PCView.
7.
Notice: Disconnecting the JNSGyro-4T from the computer before
exiting will eliminate any possible conflict in the
management of your serial ports.
Repeat these steps with other boards.
8.
Once the JNSGyro-4T's boards are configured, the configuration will remain
until you change it either using PCView or clearing the boards NVRAM.
2-10 JNSGyro-4T Operator's Manual www.javad.com