Javad JNSGyro-4T Operator's Manual page 34

C O N F I G U R A T I O N
2
Connecting the JNSGyro-4T and a Computer
Note that the lower-left hand corner shows the board status as
"Disconnected".
On the Connection Parameters dialog box, select the following
parameters and click Connect (Figure 2-3):
Once a PCView connection with the board has been established, the current
communications settings – such as, port name, baud rate (if applicable), and
2-4 JNSGyro-4T Operator's Manual
Figure 2-2. PCView Main Window
–Set the Connection mode (Direct).
–Set the port for your computer (typically COM1, COM2 for RS232
connection) from the Port drop-down list.
–Set the communication rate between the board and the computer
(usually 115200) from the Baud rate drop-down list.
–Enable RTS/CTS handshaking.
Figure 2-3. RS-232 Connection Parameters
www.javad.com