Harris RF-7800W Student Manual page 37

For easy access, we have provided the web access to the radio and you can
telnet into the device.
HTTP Enable: Check this box to enable the HTTP (Web) interface. If the option
is deselected, only CLI commands will be available.
Telnet Enable: Check this box to enable a Telnet access (CLI) to the radio.
If the setting in the Configuration Menu is not listed in this guide, then leave the
setting at its default setting. Do not change anything other than what is listed in
this guide.
Wireless Configuration
Use settings on the following screen to configure the radio's wireless interface.
RF Freq. [MHz]: Enter the center frequency for the RF channel. This setting
must be identical for both systems operating as a wireless link.
Important: To minimize interference, the channel frequencies for links
operating in close proximity should be separated by a minimum of the channel
size in use (to avoid overlapping bands).
Tx Power [dBm]: Enter the transmit power level (dBm). This setting is for the
transceiver output only. If this is not set to 20, then change the Tx Power to 20.
When ATPC is enabled, the Tx power will be automatically adjusted to achieve
optimum performance.
ATPC Enable: Check this box to enable the radio to monitor the received signal
and request that the remote system adjustment its transmit level for optimum
performance. The ATPC feature must be enabled on both radio units. This
should be on by default. Leave on if already checked; If not on, put a check in
the box.
Adaptive Modulation: Check this box to enable the radio to automatically adjust
the transmission modulation and code settings to achieve the highest Uncoded
Burst Rate. This should be on by default. Leave on if already checked; If not on,
put a check in the box.
Channel Width [MHz]: Select the channel bandwidth. There are three available:
10MHz, 20MHz, and 40MHz. Your cut sheet will provide the channel and
frequency. If there are no restrictions, try all channels to find the most stable and
the highest Uncoded Burst Rate.
System Mode: Set the operating mode for each radio system.
PTP Master: This unit begins transmitting automatically, sends poll messages to
the remote radio, and negotiates the wireless link.
32