Table of Contents
Advertisement
2b. Fine tuning of the standing angle (if required)
INFORMATION
Very slow extension (fig. 3): Actively standing up from sitting at this speed would take more than 5 seconds.
2c. Unblocking the standing angle
INFORMATION
Quick extension (fig. 4): Actively standing up from sitting at this speed would take less than 2 seconds. The
standing mode function remains turned on. A new standing angle can be selected at any time by repeating steps
2a./2b. 1st mode remains active.
Explanation of arrow symbols:
Flexion/Extension
Turning the standing mode function off:
Requirement: The knee joint is fully bent (the patient is seated).
INFORMATION
After the joint's confirmation with the beep signal, check whether the joint is still in the 1st mode (see Section
2.9.1).
20 Ottobock
1 To optimize the angle, very slowly continue to extend the joint (70 –
7°; Fig. 3).
2 The blocked joint can be fully loaded in the flexion direction.
3
1 The standing angle can be unblocked at any time by either a quick
extension movement or complete extension (7 – 0°, Fig. 4).
4
Very slow extension
1
Slow extension
1 Activation of the remote control: Press key 3
and kep it pressed (Fig. 1) until the joint confirms the
activation with a vibration signal.
2 Turning the standing mode function off: Within
3 seconds after activation of the remote control si-
multaneously press the keys 1 and 2 (Fig. 2) until the
joint confirms turning off of the standing mode with
one short beep signal.
2
Quick extension
C-Leg Prosthetic System
Advertisement
Table of Contents
