Adjusting The Angle Of The Elevating Leg Support - Otto Bock Motus CV Instructions For Use Manual

53
Segmented footplate
1) Loosen the Allen screw on the foot plate suspension (see fig. 54).
2) Turn the foot plate to the desired angle.
3) Tighten the Allen screw to 6 Nm.
54
"Elevating" leg support on Motus CV
1) Loosen the Allen screw on the foot plate suspension (see fig. 54).
2) Turn the foot plate to the desired angle.
3) Tighten the Allen screw to 6 Nm.

6.7.3 Adjusting the angle of the elevating leg support

The following steps also apply for the amputation leg support (see fig. 55).
1) Turn the release lever upwards to the stop (see fig. 56, item 1).
Alternative: The leg support can also be elevated without operating the release lever.
2) Simultaneously move the leg support to the desired angle (see fig. 57, item 2).
3) Turn the release lever back.
→ The leg support will automatically snap into place in the next free position.
Motus CV, Motus CS
Settings
25