Adjusting The Seat Upholstery - Otto Bock Motus CV Instructions For Use Manual

Settings
2) Loosen and remove the Allen screws between the back support upholstery and the back support tubes (see
fig. 44, item 1).
3) Slide the back support upholstery up.
4) Loosen and remove the Allen screws on the back support tubes (see fig. 45, item 1).
5) Pull the back support tubes out of the back support upholstery.
6) Remove the back support upholstery.
Attaching the back support upholstery
1) Insert the back support tubes into the back support upholstery.
2) Attach the back support tubes. Tighten the Allen screws to 7 Nm.
3) Tighten the Allen screws between the back support upholstery and the back support tubes to 2 Nm.
4) Fasten the hook-and-loop closures on the back support upholstery.
43
45

6.6.2 Adjusting the seat upholstery

The seat upholstery usually does not need to be adjusted during the initial fitting. However, re-tightening the slack
is possible. Corrections to the centre of gravity must be made by making changes to the settings on the frame, the
axle unit and the caster wheels.
"Complete" (two-piece) seat upholstery and seat upholstery with storage compartments
> Prerequisites:
The seat cushion has been removed.
1) Remove the plugs (see fig. 46, item 1).
2) Slightly fold the crossbrace and pull the seat upholstery out of the crossbrace (see fig. 47).
3) Unfasten the hook-and-loop fastener on the underside of the seat upholstery (see fig. 48, item 1).
4) Tighten or loosen the seat upholstery. Close the hook-and-loop fastener again. Make sure the upholstery bars
are inserted correctly (see fig. 48, item 2).
5) Slide the seat upholstery onto the crossbrace with the help of the upholstery bars (see fig. 49, item 1).
6) Replace the caps and insert them into the frame tubes using a soft-faced hammer.
7) Unfold the wheelchair. The crossbrace must be seated fully in the support guides as you do so.
22
44
Motus CV, Motus CS