Otto Bock Motus CV Instructions For Use Manual page 33

Motus
Horizontal axle position [mm]
1)
With wheelbase extension: rear axle position + 73 mm
2)
Applicable to handrim attachment, narrow and 0° drive wheel camber
3)
In accordance with ISO 7176-5
4)
Measured in reference to the middle of the back support
Front seat height [mm]
Caster fork
Short
Long
Rear seat height [mm]
Drive wheel size
Ambient conditions
Temperatures and relative humidity
Temperature during use [°C (°F)]
Transport and storage temperature [°C (°F)]
Relative humidity [%]
12 Appendices
12.1 Required tools
The following tools are required for adjustments and maintenance work:
• Allen keys in sizes 3, 4, 5
• Allen key (DIN 6911) of sizes 4, 5 and 6
• Ring and open-end wrenches in sizes 10, 11, 19, 24 and 27
• Socket wrenches in sizes 10, 19 and 27
• Phillips head screwdriver (size: 2)
• Screwdriver (blade width: 2.5 mm)
• Torque wrench (measurement range 3–50 Nm)
12.2 Torque values of the screw connections
Unless otherwise specified, screw connections are tightened with the following torque values:
• Thread diameter M4: 3 Nm
• Thread diameter M5: 5 Nm
• Thread diameter M6: 8 Nm
• Thread diameter M8: 20 Nm
Motus CV, Motus CS
4)
4" 5"
380 – 460 380 – 470
440 – 530 460 – 540
24"
Minimum Maximum
33 106.5
Wheel diameter
5.5"
400 – 480
440 – 550
Setting range
360 – 520
-10 to +40 (14 to 104)
-10 to +40 (14 to 104)
45 to 85; non-condensing
Appendices
6" 7"
400 – 480 420 – 490
430 – 550 440 – 550
33