Adjusting The Quick-Release Axle; Adjusting The Handrims - Otto Bock Motus CV Instructions For Use Manual

11

6.2.5 Adjusting the quick-release axle

The quick-release axle should be set so the wheel is correctly engaged, with no play on the axle.
1) Hold the quick-release axle by the head (wrench size: 19 mm) and by the tip (wrench size: 11 mm) with a ring
and open-ended wrench respectively.
2) Adjust the play by turning the nut on the end of the quick-release axle (see fig. 12, item 1) in or out.
12

6.2.6 Adjusting the handrims

INFORMATION
This section does not apply to standard wheels.
All handrims are designed for a spacing from the drive wheel of 15 mm (standard setting) and 25 mm (see fig. 13).
1) Loosen/remove the handrim screw connections from the rim.
2) Tightly screw the handrims onto the rim in narrow or wide installation position (see fig. 14).
13
Motus CV, Motus CS
14
Settings
13