Instructions D'utilisation - Otto Bock 17B66 16 Instructions For Use Manual

► Install the bearing ball (5), stop pins (6) and spring (7) with the set screws (1) in the combination required. Use
Loctite® 241 to secure the set screws (1).
6 Cleaning
System joints must be cleaned promptly after contact with water containing salt, chlorine or soap, or when they get
dirty.
1) Rinse system joints with clean fresh water.
2) Dry system joints with a cloth or allow to air dry. Avoid exposure to direct heat (e.g. from an oven or radiator).
7 Maintenance
INFORMATION
The product may be exposed to increased loads by the patient.
► Shorten the maintenance intervals according to the expected loads.
The manufacturer requires at least a semi-annual inspection of the product to verify functionality and check for
wear.
Performing maintenance
► Lubricate the system ankle joints. Only use 633F7 special lubricant.
Individual spare parts and service set
Spare part
Set screw (1)
Truss head screw (2)
Bearing nut (3)
Bearing ball (5)
Stop pin (6)
Spring (7)
8 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
8.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
8.2 CE conformity
The product meets the requirements of Regulation (EU) 2017/745on medical devices. The CE declaration of con­
formity can be downloaded from the manufacturer's website.
1 Avant-propos
INFORMATION
Date de la dernière mise à jour : 2020-02-13
► Veuillez lire attentivement l'intégralité de ce document avant d'utiliser le produit ainsi que respecter les
consignes de sécurité.
► Apprenez à l'utilisateur comment utiliser son produit en toute sécurité.
► Adressez-vous au fabricant si vous avez des questions concernant le produit ou en cas de problèmes.
► Signalez tout incident grave survenu en rapport avec le produit, notamment une aggravation de l'état de san­
té, au fabricant et à l'autorité compétente de votre pays.
► Conservez ce document.
17B66=16, 17B66=2017B66=A-16, 17B66=A-20
Single component
Article number
506G3=M6x6
501S32=M6x14x10
17Y93=9x6.25xM6
509Y1=5.0
506A8=2.5x18
506A8=5x22
513D18=4.7x31
Service set
Quantity Article number
4 17B66=S
2
2
4
4
4
4
Cleaning
Français
9