Table of Contents
Advertisement
1) Attach the drive wheels to the quick-release axle mounting (see fig. 4). The quick-release axles must not be
removable after releasing the push-button.
INFORMATION: With "lock-release assist" option: see Page 25. With "drive wheel for one-handed
operation" option: see Page 26.
2) Loosen the safety strap (see fig. 5).
3) Unfold the wheelchair (see fig. 6).
INFORMATION: While you are next to the wheelchair, tip it slightly toward you and press on the edge
of the seat upholstery closest to you.
4) Only with "drive wheel for one-handed operation" option: Insert the telescoping rod (see Page 26).
5) If necessary: Attach the leg supports (see Page 16).
Fold down the foot plates. When using a single-panel foot plate, be sure the support of the foot plate is locked
into the receiver (see fig. 7).
6) Fit the seat cushion (see Page 20). The seat cushion is secured against sliding by being pressed onto the
hook-and-loop closure.
4
6
7 Use
7.1 Instructions for use
•
Attaching loads (e.g. backpacks) can adversely affect stability. Therefore, suspending additional loads on the
wheelchair is not permitted.
•
The recommended overall width for manual wheelchairs in an operational state is 700 mm. This specification
should ensure unhindered use of escape routes, for example. Please note that the product dimensions can
exceed the recommended value in versions with very large seat widths (for more information see see Page 45
ff.).
•
The wheelchairs in this series fully satisfy the minimum technical requirements for wheelchairs transportable by
train. However, please note that it is possible that not every individual wheelchair will fulfil the minimum require
ments due to the variation in designs (please see see Page 46 for further details).
Avantgarde 4
5
7
Use
15
Advertisement
Table of Contents
