C Seat - Otto Bock Start M1 Intro Service Manual

4.C - Seat
Replacing the center crossbrace mounting kit
Loosen and remove the screws as shown in the
photo and pull the plastic half-shells out from be-
tween the crossbrace tubes.
For reassembly, please proceed in reverse order.
Use new, self-locking nuts.
Attention: With removal of the central screw connection of the mounting kit, the stability of the crossbrace
and frame gets lost. Attach a new mounting kit before moving the chair.
Replacing the crossbrace brackets
After loosening and removing the screw connection you
can unclip the crossbrace bracket from the frame and
replace it.
Please pay attention to the scale as decribed above.
Scale on the crossbrace bracket
The crossbrace brackets are provided with a scale
showing the appropriate setting for the correspond-
ing seat width.
Replacing the seat upholstery
First remove the front end stoppers using a (not too
sharp-edged) screwdriver.
If the wheelchair is unfolded, slightly fold it to reduce
the tension on the seat upholstery and then pull the seat
upholstery out of the crossbrace's profile tubes.
For reassembly, please proceed in reverse order.
5