Xantrex BC3012 User Manual page 24

Introduction
6. Repeat steps 1 through 4 for all banks attached to the BC Series. Each time y e s
is displayed for a newly programmed battery type, the charger exits the
programming mode.
7. At any time during setup, you can press
change and return to charging or battery monitoring.
To configure the charging type:
1. Press and hold
2. Press
selected a charging type that is different from the present configuration, the
bank indicator light flashes.
See "About Charging" on page 2–2.
3. Press and hold
4. At any time during setup, you can press
change and return to charging or battery monitoring.
1–12
until s e t (setup) is displayed.
MODE
to select 2-stage ( 2 s t ) or 3-stage ( 3 s t ) charging. When you have
MODE
/
ON STANDBY
/
ON STANDBY
until y e s is displayed to store the selected mode.
/
ON STANDBY
once to cancel the current
once to cancel the current
975-0188-01-01