Ez-Kit Lite Installation - Analog Devices ADSP-BF707 EZ-KIT Lite Manual

Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from

EZ-KIT Lite Installation

It is assumed that the CrossCore Embedded Studio software is installed
and running on your PC.
Follow these instructions to ensure correct operation of the product soft-
ware and hardware.
Step 1: Connecting an emulator to the EZ-KIT Lite.
1. Plug one side of the included USB cable into the USB connector of
the emulator. Plug the other side into a USB port of the PC.
2. The status LED (labeled
nection with the PC is working and the appropriate Windows
driver is installed. Please refer to the appropriate emulator manual
if the status LED does not turn on.
3. Attach the emulator header (
the connector on the EZ-KIT Lite.
P3
Step 2: Attach the provided cord and appropriate plug to the 5V power
adaptor.
1. Plug the jack-end of the assembled power adaptor into the power
connector
P13
2. Plug the other side of the power adaptor into a power outlet. The
power LED (labeled
board.
ADSP-BF707 EZ-KIT Lite Evaluation System Manual
Using ADSP-BF707 EZ-KIT Lite
) should light up green if the con-
STATUS
on the bottom of the ICE-1000 to
J2
(labeled ) on the EZ-KIT Lite.
5V
) lights green when power is applied to the
PWR
1-5