Analog Devices ADSP-BF707 EZ-KIT Lite Manual page 46

Software-Controlled Switches (SoftConfig)
Bit Signal Name
6
7
2-12
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Table 2-7. Output Signals of Microchip GPIO Expander
(U39 Port B) (Cont'd)
Description
Connects
CAN0_ERR_EN
nal to processor
Connects
CAN1_ERR_EN
nal to processor
Table 2-8 and Table 2-9
expander ( ), with a TWI address of 0100 010X, where X represents the
U38
read or write bit. The signals that control an individual FET have an entry
under the FET column. The Component Connected column shows the
board IC that is connected if the FET is enabled. Note that some of the
Microchip ( ) output signals are connected directly to components on
U38
the board. However, in most cases, the Microchip (
enable signal of a FET switch. Also note that if a particular functionality
of the processor signal is being used, it will be in bold font under the Pro-
cessor Signal column.
ADSP-BF707 EZ-KIT Lite Evaluation System Manual
FET Processor Signal
(if applicable)
error sig-
CAN U6 PB_02/
EPPI0_D05/
SPT1_BD0/
SPI0_MOSI/
SMC0_D05
error sig-
CAN U9 PB_03/
EPPI0_D04/
SPT1_BD1/
SPI0_D2/
SMC0_D04
show the output signals of the Microchip GPIO
Component Default
Connected
High
U46
High
U47
) is controlling the
U38