Ez-Kit Lite Installation - Analog Devices ADSP-BF592 EZ-KIT Lite Manual

EZ-KIT Lite Installation

For correct operation, install the software in the order presented in the
VisualDSP++ Installation Quick Reference Card. Substitute instructions in
step 3 with instructions in this section.
There are two options to connect the EZ-KIT Lite hardware to a personal
computer (PC) running VisualDSP++ 5.0: via an Analog Devices emula-
tor or via the onboard debug agent.
To connect the EZ-KIT Lite to a PC via an emulator:
1. Plug the 5V adaptor into connector
USB cable into connector
2. Attach the emulator to the header connector
the EZ-KIT Lite.
To connect the EZ-KIT Lite to a PC via the debug agent:
1. Plug one side of the provided USB cable into the USB connector of
the debug agent
into a USB port of the PC running VisualDSP++.
2. Verify that the yellow USB monitor LED on the debug agent,
, is lit. This signifies that the board is communicating prop-
ZLED2
erly with the host PC and ready to run VisualDSP++.
ADSP-BF592 EZ-KIT Lite Evaluation System Manual
Using ADSP-BF592 EZ-KIT Lite
(labeled
ZP1
(labeled ). Plug the other side of the cable
ZP1 USB
(labeled ) or plug the
P9 5V
).
USB
(labeled
P2
) on
JTAG
1-5