Table of Contents
Advertisement
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
For more information, refer to the CAN0 example in the POST, which is
included in the ADSP-BF707 Board Support Package.
CAN1 Interface
The Controller Area Network 1 (
connected to the NXP TJA1041 CAN transceiver (
attached to the
CAN1
nector (
). See
CAN1 Connector
J5
The
transmit and receive signals are connected through the SoftCon-
CAN1
fig switches and enabled by default.
(error) and
CAN1_ERR_EN
Switches
(SoftConfig).
For more information, refer to the CAN1 example in the POST, which is
included in the ADSP-BF707 Board Support Package.
USB Interface
The ADSP-BF707 processor has an integrated USB PHY; the EZ-KIT
Lite provides a micro AB connector. The board supports USB high speed
mode.
The board supplies a maximum of 5V at 500 mA to a peripheral device by
enabling the FET switch (
switch through the
USB0_VBC
To learn about the processor's device and host modes, refer to the USB
example in the POST, which is included in the ADSP-BF707 Board Sup-
port Package. For more information, refer to the hardware reference
manual.
ADSP-BF707 EZ-KIT Lite Evaluation System Manual
Using ADSP-BF707 EZ-KIT Lite
) interface of the EZ-KIT Lite is
CAN1
port of the ADSP-BF707 processor via an RJ-11 con-
(J5).
CAN1_EN
are disabled. See
CAN1_STB
). The USB controller controls the FET
U40
signal.
). The transceiver is
U47
is enabled by default.
Software-Controlled
1-11
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-BF707 EZ-KIT Lite and is the answer not in the manual?