Cellular Lock - ZyXEL Communications Nebula LTE3301-PLUS User Manual

Table 30 Network Setting > Broadband > Cellular IP Passthrough (continued)
LABEL
Passthrough
Mode
Passthrough
to fixed MAC
Apply
Cancel

7.10 Cellular Lock

Cellular Lock locks the CPE to the base station that it is currently connected to. This is useful if the CPE is
within range of multiple base stations, and you would prefer the CPE to connect to one base station
over the others.
Click Network Setting > Broadband > Cellular Lock. The following screen displays.
Figure 61 Cellular Lock
The following table describes the fields in this screen.
Table 31 Cellular Lock
LABEL
PCI Lock
Add New Rule
Physical Cell ID
RFCN
Chapter 7 Broadband
DESCRIPTION
Select Dynamic to allow traffic to be forwarded to the first LAN computer on the local network of
the Zyxel Device. Select Fixed to allow traffic to be forwarded to a specific computer (for
example, Client A) by entering its MAC address.
Note: This field will show after enabling IP Passthrough in the previous field.
Enter the MAC address of a LAN computer on the local network of the Zyxel Device upon
selecting Fixed in the previous field.
Note: This field will show after selecting Fixed in the previous field.
Click this to save your changes.
Click this to exit this screen without saving.
DESCRIPTION
Select this to enable or disable PCI (Physical Cell Identifier) Lock.
Select this if you want to add a new rule or to configure cellular lock rules.
Use this to enter the PCI number of the base station you choose to connect to (0 – 504).
Use RFCN (Radio Frequency Channel Number) to enter the LTE frequency of the
specified PCI number(1 – 65535).
Nebula Mobile Router User's Guide
120