Add Or Edit Policy Route - ZyXEL Communications Nebula LTE3301-PLUS User Manual

through specific connections or distribute traffic across multiple paths for load sharing. Policy-based
routing is applied to outgoing packets before the default routing rules are applied.
The Policy Route screen let you view and configure routing policies on the Zyxel Device. Click Network
Setting > Routing > Policy Route to open the following screen.
Figure 103 Network Setting > Routing > Policy Route
The following table describes the labels in this screen.
Table 59 Network Setting > Routing > Policy Route
LABEL
Add New Policy
Route
#
Status
Name
Source IP
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source
Interface
WAN Interface
Modify

10.4.1 Add or Edit Policy Route

Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use this
screen to configure the required information for a policy route.
Chapter 10 Routing
DESCRIPTION
Click this to create a new policy forwarding rule.
This is the index number of the entry.
This field displays whether the DNS route is active or not. A yellow bulb signifies that this DNS route
is active. A gray bulb signifies that this DNS route is not active.
This is the name of the rule.
This is the source IP address.
This is the source subnet mask address.
This is the transport layer protocol.
This is the source port number.
This is the source MAC address.
This is the interface from which the matched traffic is sent.
This is the WAN interface through which the traffic is routed.
Click the Edit icon to edit this policy.
Click the Delete icon to remove a policy from the Zyxel Device. A window displays asking you to
confirm that you want to delete the policy.
Nebula Mobile Router User's Guide
182