ZyXEL Communications Nebula LTE3301-PLUS User Manual page 295

Make sure the power source is turned on.
2
Turn the Zyxel Device off and on.
3
If the problem continues, contact the vendor.
4
The LED does not behave as expected.
Make sure you understand the normal behavior of the LED. See
1
Check the hardware connections.
2
Inspect your cables for damage. Contact the vendor to replace any damaged cables.
3
Turn the Zyxel Device off and on.
4
If the problem continues, contact the vendor.
5
37.3 Device Access Problems
I do not know the IP address of the Zyxel Device.
The default IP address is 192.168.1.1.
1
If you changed the IP address, you might be able to find the IP address of the Zyxel Device by looking
2
up the IP address of your computer's default gateway. To do this in Microsoft Windows, click Start > Run,
enter cmd, and then enter ipconfig. The IP address of the Default Gateway might be the IP address of
the Zyxel Device, depending on your network environment.
If this does not work, reset the Zyxel Device to its factory defaults.Refer to
3
I forgot the admin password.
See the Zyxel Device label or this document's cover page for the default admin password.
1
If you changed the password from default and cannot remember the new one, you have to reset the
2
Zyxel Device to its factory default settings. Refer to
I cannot access the Web Configurator login screen.
Chapter 37 Troubleshooting
Section 35.2 on page
Nebula Mobile Router User's Guide
300
Section 2.2 on page 24.
Section 35.2 on page
292.
292.