ZyXEL Communications Nebula LTE3301-PLUS User Manual page 138

Figure 74 Network Setting > Wireless > Others
The following table describes the labels in this screen.
Table 45 Network Setting > Wireless > Others
LABEL DESCRIPTION
RTS/CTS Data with its frame size larger than this value will perform the RTS (Request To Send)/CTS (Clear
Threshold To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation This is the maximum data fragment size that can be sent. Enter a value between 256 and 2346.
Threshold
Output Power Set the output power of the Zyxel Device. If there is a high density of APs in an area, decrease
the output power to reduce interference with other APs. Select one of the following: 20%, 40%,
60%, 80% or 100%.
Beacon Interval When a wirelessly networked device sends a beacon, it includes with it a beacon interval. This
specifies the time period before the device sends the beacon again.
The interval tells receiving devices on the network how long they can wait in low power mode
before waking up to handle the beacon. This value can be set from 50 ms to 1000 ms. A high
value helps save current consumption of the access point.
DTIM Interval Delivery Traffic Indication Message (DTIM) is the time period after which broadcast and
multicast packets are transmitted to mobile clients in the Power Saving mode. A high DTIM
value can cause clients to lose connectivity with the network. This value can be set from 1 to
255.
Chapter 8 Wireless
Nebula Mobile Router User's Guide
138