ZyXEL Communications Nebula LTE3301-PLUS User Manual page 29

Table 8 Nebula NR5101 Panel Ports and Buttons
LABELS
ANT1-ANT2 / Antenna
USB
LAN2/WAN
LAN1
WiFi
RESET
POWER Button
POWER
Micro SIM
INT/EXT
Table 9 Nebula NR7101 Panel Ports and Buttons
LABELS
USB (Type-C)
LAN (PoE)
SIM card
Table 10 Nebula LTE7461-M602 Panel Ports and Buttons
LABELS
LAN (PoE)
WiFi
WPS
RESET
SIM card
Chapter 2 Hardware Panels
DESCRIPTION
Install the external antennas to strengthen the cellular signal.
Note: To use the external antennas, you must set the INT/EXT switch to EXT.
The USB port of the Zyxel Device is used for file sharing.
LAN mode: Connect a computer to the LAN using an RJ45 cable.
WAN mode: Connect the Zyxel Device to the Internet through the WAN.
Connect a computer to the LAN using an RJ45 cable.
Press for 1 second: Enable or disable WiFi.
Press for more than 5 seconds: Activate WPS connection process.
Press for 2 seconds: Reboot the Zyxel Device.
Press for 5 seconds: Restore the Zyxel Device to its factory default settings.
Press the POWER button after the power adapter is connected to start the Zyxel Device.
Connect the power adapter and press the POWER button to start the Zyxel Device.
Insert a micro-SIM card into the slot with the chip facing down and the beveled corner
in the top left corner.
Select between the internal or external cellular antennas.
DESCRIPTION
The USB port of the Zyxel Device is used for maintenance only.
Note: The USB port can only be used by qualified technicians.
Connect the PoE port on the PoE injector to the Zyxel Device's LAN port through an
Ethernet cable. Connect the LAN port on the PoE injector to your computer's RJ45 port
through another Ethernet cable.
Insert a micro-SIM card into the slot with the chip facing down and the beveled corner
in the top left corner.
DESCRIPTION
Connect a computer through the PoE injector for configuration.
Connect the PoE injector to a power outlet to start the device.
Press the WLAN (WiFi) button for more than 5 seconds to enable WiFi.
After WiFi is enabled, press the WLAN button for more than one second but less than
5 seconds to quickly set up a secure WiFi connection between the Zyxel Device and
a WPS-compatible client.
Press the button for more than 5 seconds to return the Zyxel Device to the factory
defaults.
Insert a micro-SIM card into the slot with the chip facing down and the beveled
corner in the top left corner.
Nebula Mobile Router User's Guide
29