Table of Contents
Advertisement
Optional manual regeneration
If the machine is not used for a long time when the engine is operating in automatic regeneration, automatic regener-
ation may not start or complete normally.
In such a case, manual regeneration may be completed automatically by stopping automatic regeneration and exe-
cuting optional manual regeneration.
Note that the machine cannot be operated in optional manual regeneration and the regeneration time takes longer.
When the switch is held for 3 seconds when automatic regeneration is stopped, the orange lamp blinks for 10 seconds
and operation changes into manual regeneration.
When the switch is pressed again while the orange lamp is blinking, manual regeneration starts.
Do not press the switch if manual regeneration should not be started.
The blinking orange lamp goes out 10 seconds later.
1. In automatic regeneration.
• The green lamp is lit.
• The following message is displayed cyclically.
Auto DPD Re-gen
2. Pressing the switch.
3. Automatic regeneration stops.
• The green lamp goes out.
• The following message is displayed.
Push DPD switch to activate
4. Move the machine to a safe place with no combustible objects.
• Set the function cancellation lever to the lock position (safety bar retracted).
5. Hold the switch for 3 seconds to move to optional manual regeneration.
6. Moves to manual regeneration.
• The orange lamp blinks.
• The buzzer sounds for 2 seconds.
• The following message is displayed.
Push DPD switch to activate
3 - CONTROLS/INSTRUMENTS
7
XNNFHF-001Z
3-45
Advertisement
Table of Contents
