Case CX300C Operator's Manual page 217

Crawler excavator
Hide thumbs Also See for CX300C:
Table of Contents

Advertisement

Level in the reservoir
1. Place the machine on flat, level ground and place the
attachment in the position shown. Stop the engine and
remove the ignition key.
2. The oil should be in the middle of the indicator. Add
more oil if necessary. See "Filling the reservoir".
Filling the reservoir
1. Release all pressure in the hydraulic reservoir. Refer
to page 6-32.
2. Clean the cover plate and the area around the plate.
Remove the cover plate and add hydraulic fluid to the
reservoir as required.
3. Replace the cover plate seal if required and install the
cover plate.
NOTICE: Make sure that no contaminant (water, sand
etc.) enters the reservoir during filling.
6 - MAINTENANCE
6-35
1
INHU39-003
2
UJHECF-006
3
YNQGSC-002

Advertisement

Table of Contents
loading

Table of Contents