Unloading
1. Remove the blocks and fastening chains.
2. Start the engine.
3. Push the function cancellation lever forward (safety
bar in outward position).
4. (Machine with attachment)
Raise the attachment to bring it a few centimetres
above the trailer bed.
5. Select low travel speed.
6. Move the machine forward slowly, raising the attach-
ment (if equipped) so as to keep it a few centimetres
off the ground.
7. Turn the rear view mirrors back to their correct posi-
tion.
8. (Machine without attachment)
Install the attachment and the counterweight.
ATTENTION: When the attachment has been installed,
all air must be removed from the hydraulic circuit and the
machine must be tested for correct operation. Do not for-
get to check the oil level.
5 - TRANSPORT OPERATIONS
5-5