Case CX300C Operator's Manual page 138

Crawler excavator
Hide thumbs Also See for CX300C:
Table of Contents

Advertisement

7. When the icon disappears, turn the ignition key to the
"Start" position. Release the key as soon as the en-
gine starts to turn. If the engine stops, wait about a
minute and perform the operation again.
NOTICE: Do not operate the starter motor for more than
ten seconds at one time. Do not operate the starter motor
when the engine is running.
8. Run the engine until the "Automatic heating" icon dis-
appears from the systems display panel.
9. Push the function cancellation lever forward (safety
bar in outward position).
NOTE: Check the systems display and console frequently
while the engine is running. (Refer to page 4-10).
NOTICE: This machine is equipped with a new type of en-
gine incorporating a high-pressure fuel injection system
which reduces the emission to the environment and re-
spects the regulations applicable to level 4 engine emis-
sions. Starting this engine takes about 1 second before
stabilisation.
NOTICE: If the engine does not start at the first attempt,
operate the starter motor for 10 seconds then wait for 1
to 2 minutes before retrying. When cold, the engine is at
times difficult to start. But in all cases, do not operate the
starter motor for more than 10 seconds.
4 - OPERATING INSTRUCTIONS
4-8
4
HISNJU-005BZ
5
HISNJU-006BZ
6
HISNJU-008

Advertisement

Table of Contents
loading

Table of Contents