Table of Contents
Advertisement
Greasing the turntable teeth
Grease capacity: 17 kg (37.5 lb)
Type of grease: (refer to page 6-5)
Every 500 hours
Remove the inspection cover (1) and visually check the
condition of the gear surface and for any damage.
If the gear surface is not well greased, add grease.
If the grease is white due to moisture content, etc. replace
it with new grease.
If the presence of water is detected, remove the plug (2)
and drain off the water.
1. Remove the protective panel from the lower central
area.
2. Remove plug (2).
3. Discharge the water or contaminated grease.
4. Install plug (2).
5. Insert new grease through the port and install the in-
spection cover (1).
Greasing the swing reduction gear
Grease capacity: 0.8 kg (1.8 lb)
Type of grease: (refer to page 6-5)
Every 2000 hours
Remove the lower panel, remove the air bleed plug (1)
and refill with grease through the grease point (2).
A certain amount of grease should run out from the air
bleed plug (1).
Install the air bleed plug (1) then install the lower panel.
NOTICE: When greasing, the inner seal will be damaged
if the air bleed plug (1) is not removed.
6 - MAINTENANCE
6-17
17
5ZISAG-007
18
5ZISAG-004
19
ELVIVS-005
Advertisement
Table of Contents
