Connecting the Management Interface
Figure 5-2
Initial Setup Configuration (continued)
Parameter
Domain name server
RDR formatter
destination
Connecting the Management Interface
The SCE8000-SCM-E is equipped with one active RJ-45 management port. This port provides access
from a remote management console to the Cisco SCE8000 via a LAN.
The procedures for cabling the GBE management port and testing connectivity between the Cisco
SCE8000 and the remote management host are explained in the following sections.
•
•
How to Cable the Management Port
The SCE8000-SCM-E has one GBE port that is used as the management port, located in slot# 1 of the
Cisco SCE8000 chassis, and labeled Port1.
Plug the Ethernet cable provided (with attached RJ-45 connector) into Port 1on the front panel of the
Step 1
SCE8000-SCM-E. (See item #3 in
Figure 5-3
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
5-4
show command
show hosts
show rdr-formatter destination rdr-formatter destination
How to Cable the Management Port, page 5-4
How to Verify Management Interface Connectivity, page 5-5
Cabling the Management Port
S C E 8 0 0 0
-S C M -E
O P T IC A
B Y P A S
configuration command
ip domain-lookup
ip domain-name domain-name
ip name-server server-address1
[server-address2] [server-address3]
ip-address port port-number
Figure 5-3
below.)
1
2
3
L
S 1
C O N S O
L E
P O R T 1
1 0 /1 0 0 /
L IN K /
1 0 0 0
A C T IV E
Chapter 5
Connecting the Management Interfaces
configuration command
mode
Global Configuration
Global Configuration
OL-16478-03