Connecting A Serial Interface Port To A Csu/Dsu Or A Synchronous Modem - Cisco IAD2430 Series Hardware Installation Manual

Chapter 3 Installing Cisco IAD2430 Series IADs
Figure 3-24
Step 4 Pull the Velcro strap up until tight, then down and affix the strap to other Velcro side (see
Figure 3-25

Connecting a Serial Interface Port to a CSU/DSU or a Synchronous Modem

Use the procedure in this section to connect the serial interface port to a CSU/DSU or to a synchronous
modem.
The serial port (S0) can operate as follows:
•
OL-4234-06
Tightening the Captive Screws
Tightening the Velcro Strap
DTE or DCE with the following signaling:
– EIA/TIA-232
– EIA-TIA-449
– V.35
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
F X S
W A N
T 1 /E 1
F X S
IA D 2 4 3 5 -8
W A N
F a st E th e rn
T 1 /E 1
0 /1
Connecting Cables
IA D 2 4 3 5 -8
F X S
F a st E th e rn
e t
0 /1
0 /0
Figure 3-25).
F X S
e t
0 /0
3-27