Viewing The Ten Gigabit Ethernet Counters - Cisco SCE8000 Installation And Configuration Manual

Starting the Cisco SCE8000 Platform
Viewing the Ten Gigabit Ethernet Port Status
At the Cisco SCE8000# prompt, type show interface TenGigabitEthernet 3/ baynumber /0.
Step 1
This displays the port link status.
The following example displays a system response.
Cisco SCE8000#show interface TenGigabitEthernet 3/1/0
Actual Status:
Link is on
Bandwidth: 10000000Kbps
Burst-size: 500000bytes

Viewing the Ten Gigabit Ethernet Counters

In an inline topology, you can monitor traffic via the platform counters for both the Rx and Tx
connections. The counters increase as packets flow through the Cisco SCE8000 for both Rx and Tx.
However, in receive-only topologies, the counters for the Tx do not increment, as the SCE8000 is only
monitoring traffic, and not re-transmitting it
Step 1 At the Cisco SCE8000# prompt, type show interface TenGigabitEthernet 3/ baynumber /0 counters.
This displays the TenGigabitEthernet counters. This command enables you to verify that there is traffic
on the line. You can see that the counters increase, together with real-time packet flow through the Cisco
SCE8000.
Remember, in bump-in-the-wire topology, both the Rx and Tx counters apply as traffic monitors. For
receive-only topologies, using an external splitter, only the Rx counters apply.
The following example shows the counters of the first Ten Gigabit Ethernet interface.
Cisco SCE8000#show interface TenGigabitEthernet 3/0/0 counters
In total octets: 100
In good unicast packets: 90
In good multicast packets: 0
In good broadcast packets: 10
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Out total octets: 93*2^32+1022342538
Out unicast packets: 858086051
Out non unicast packets: 0
Out packets discarded: 0
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
7-4
Chapter 7 Basic Cisco SCE8000 Platform Operations
OL-16478-03