Installing The Fan Assembly - Cisco SCE8000 Installation And Configuration Manual

Removing and Replacing the Fan Assembly
Figure 9-7 Fan Assembly
SCE 8000
FA N
ST AT U
S
SCE 8000
SCE 8000
Captive installation screws
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the fan
blades completely stop before you remove the fan tray.
Grasp the fan assembly with both hands and pull it outward; rock it gently if necessary to unseat the
Step 2
power connector from the backplane.
Pull the fan assembly clear of the chassis, and put it in a safe place.
Step 3

Installing the Fan Assembly

Hold the fan assembly with the fans facing to the right and the FAN STATUS LED at the bottom. (See
Step 1
Figure
Place the fan assembly into the front chassis cavity so that it rests on the chassis, and then lift the fan
Step 2
assembly up slightly, aligning the top and bottom chassis guides.
Push the fan assembly into the chassis until the power connector seats in the backplane and the captive
Step 3
installation screws make contact with the chassis.
Tighten the captive installation screws.
Step 4
Verify that fans are operational.
Step 5
•
•
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
9-12
-SC M-E
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100 STA TUS
LINK
1000 OP TIC AL
ACT IVE
BY PAS S
-SC M-E
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100 STA TUS
LINK
1000 OP TIC AL
ACT IVE
BY PAS S
-SIP
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
TX
TX
TX
A
RX TX C CT RL
B
RX D
A
RX B
C
RX D
ST AT US
OP TIC AL
BY PA SS OP B- SC
1
E8 K- MM
9-7.)
Listen for the fans; you should immediately hear them operating. If you do not hear them, ensure
that the fan assembly is inserted completely in the chassis and the faceplate is flush with the switch
back panel.
Verify that the FAN STATUS LED is green. If the LED is red, one or more fans is faulty.
Chapter 9
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
Removal and Replacement Procedures
OL-16478-03