How To Display The System Uptime; Example For Displaying The System Uptime; Rebooting And Shutting Down The Sce Platform; Rebooting The Sce Platform - Cisco SCE8000 Installation And Configuration Manual

How to Display the System Uptime

How to Display the System Uptime
Use this command to see how long the system has been running since the last reboot.
Step 1 At the SCE> prompt, type show system-uptime and press Enter.

Example for Displaying the System Uptime

The following example shows how to display the system uptime of the SCE platform.
SCE#show system-uptime
Cisco SCE8000 uptime is 21 minutes, 37 seconds

Rebooting and Shutting Down the SCE Platform

•
•

Rebooting the SCE Platform

Rebooting the SCE platform is required after installing a new package, in order for that package to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
When the SCE restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
At the SCE# prompt, type reload and press Enter.
Step 1
A confirmation message appears.
Type y to confirm the reboot request and press Enter.
Step 2

Examples for Rebooting the SCE Platform

The following example shows the commands for system reboot.
SCE# reload
Are you sure? y
the system is about to reboot, this will end your CLI session
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
7-16
Rebooting the SCE Platform, page 7-16
How to Shut Down the SCE Platform, page 7-17
Saving or Changing the Configuration Settings, page
Chapter 7 Basic Cisco SCE8000 Platform Operations
7-6.
OL-16478-03