Starting The Cisco Sce8000 Platform; Checking Conditions Prior To System Startup - Cisco SCE8000 Installation And Configuration Manual

Basic Cisco SCE8000 Platform Operations
This chapter describes how to start up the Cisco SCE8000 platform, reboot, and shutdown. It also
describes how to manage configurations.
•
•
•
•
•
•

Starting the Cisco SCE8000 Platform

The procedures for starting the Cisco SCE8000 platform are explained in the following sections:
•
•
•
•

Checking Conditions Prior to System Startup

Check the following conditions before you start your Cisco SCE8000 platform:
•
•
•
OL-16478-03
Starting the Cisco SCE8000 Platform, page 7-1
Managing Cisco SCE8000 Configurations, page 7-5
How to Display the SCE Platform Version Information, page 7-10
How to Display the SCE Platform Inventory, page 7-12
How to Display the System Uptime, page 7-16
Rebooting and Shutting Down the SCE Platform, page 7-16
Checking Conditions Prior to System Startup, page 7-1
Performing Complex Configurations, page 7-2
Starting the System and Observing Initial Conditions, page 7-2
Final Tests, page 7-3
Both power supply units are installed and connected. (If only one power supply is connected it will
put the box in warning state.)
First-time startup at installation:
Cisco SCE8000 platform connected to local console (CON port)
–
The console terminal is turned on and properly configured
–
Subsequent startups
– Line interfaces are properly cabled (optional)
– Cisco SCE8000 platform is connected to at least one of the following types of management
stations:
C H A P T E R
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
7
7-1