How To Load And Activate A Service Control Application - Cisco SCE8000 Installation And Configuration Manual

How to Load and Activate a Service Control Application

The following example shows the counters of the first Ten Gigabit Ethernet interface.
Cisco SCE8000#show interface TenGigabitEthernet 3/0/0 counters
In total octets: 100
In good unicast packets: 90
In good multicast packets: 0
In good broadcast packets: 10
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Out total octets: 93*2^32+1022342538
Out unicast packets: 858086051
Out non unicast packets: 0
Out packets discarded: 0
How to View the User Log Counters
You should view the user log for errors that occurred during the installation process.
At the SCE8000# prompt, type show logger device User-File-Log counters and press Enter.
Step 1
SCE8000#show logger device user-file-log counters
Logger device User-File-Log counters:
Total info messages: 1
Total warning messages: 0
Total error messages: 0
Total fatal messages: 0
If there are "Total error messages" or "Total fatal messages", use the show logger device User-File-Log
command to display details about the errors.
How to Load and Activate a Service Control Application
The Cisco SCE8000 platform provides the basic functionalities of Service Control analysis and
enforcement. A Service Control solution requires that a Service Control application be loaded into the
platform, to take advantage of the unique SCE platform capabilities.
Loading and activating an application includes the following stages:
•
•
•
The detailed procedure of how to perform these operations is not specified and described in this manual.
For further details, refer to the following documentation:
•
•
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
6-14
Downloading the application provided as an SLI file to the Cisco SCE8000 disk.
Activating the application.
Configuring the application.
Cisco Service Control Application for Broadband User Guide
Cisco Service Control Application for Broadband Reference Guide
Chapter 6 Cabling the Line Ports and Completing the Installation
OL-16478-03