Connecting The Management Interface - Cisco SCE 2000 Platform SCE 2000 4/8xFE Installation And Configuration Manual

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
The running configuration would be overwritten by the changes you have just
entered, are you sure? [yes/no]:y
The new running configuration will be saved to the startup configuration.
Do you want to save a copy of the startup configuration file in a remote
station? [no]:y
Enter a full FTP path of the remote destination:
ftp://vk:vk@10.1.1.253/h:/copyofstartup.txt
Committing configuration...
Configuration completed successfully.
Saving configuration...
Writing general configuration file to temporary location...
Backing-up general configuration file...
Copy temporary file to final location...
Done!
E
XAMPLE
Following is an example of a configuration that was aborted, although no errors were detected.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]:
Apply and Save this configuration? [yes/no]: n
The changes you have just entered would be discarded, are you sure?
[yes/no]:y
Setup procedure aborted, no configuration changes made.

Connecting the Management Interface

The SCE platform is equipped with two RJ-45 management (MNG) ports. These ports provide
access from a remote management console to the SCE platform via a LAN. The two management
ports provide the possibility for a redundant management interface, thus ensuring management
access to the SCE platform even if there is a failure in one of the management links.
If only one management port is used, the desired port is simply connected directly to the LAN. If
both management ports are used, they must both be connected to the management console via a
switch. In this way, the IP address of the MNG port is always the same, regardless of which
physical port is currently active.
The procedures for cabling the management port and testing connectivity between the SCE 2000
and the remote management host are explained in the following sections:
•
•
OL-7826-05
3:
Cabling the Management Port (on page 5-26)
Verifying Management Interface Connectivity (on page 5-26)
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
Connecting the Management Interface
5-25