Connecting The Management Interface; Cabling The Management Port - Cisco SCE8000 Quick Start Manual

Table 2 lists commands for displaying the currently configured values and for configuring these parameters. It also lists the
command mode for each configuration command. All show commands are executed from the User Exec command mode.
Table 2 Initial Setup Configuration
Parameter
Management IP address
and subnet mask
Default gateway
Hostname
Authorization level
passwords
Clock
Time zone
Domain name server
RDR formatter
destination

Connecting the Management Interface

The SCE8000-SCM-E is equipped with one active management port. This is a GBE port with a RJ-45 interface. It is located in
slot# 1 of the Cisco SCE8000 chassis, and labeled Port1.
This port provides access from a remote management console to the Cisco SCE8000 through a LAN.

Cabling the Management Port

Plug the Ethernet cable provided (with attached RJ-45 connector) into Port 1on the front panel of the SCE8000-SCM-E
Step 1
(item #3 in Figure
show Command
show interface GigabitEthernet 1/1
ip address
show ip default-gateway
show hostname
N/A
show clock
show calendar
show timezone
show hosts
show rdr-formatter destination
9.)
Configuration Command
ip address x.x.x.x subnet-mask
ip default-gateway x.x.x.x
hostname host-name
enable password level level
[encryption-type] password
calendar set hh:mm:ss day month
year
clock read-calendar
or
clock set hh:mm:ss day month year
clock update-calendar
clock timezone zone-name
offset-hours
ip domain-lookup
ip domain-name domain-name
ip name-server server-address1
[server-address2] [server-address3]
rdr-formatter destination ip-address
port port-number
Configuration Command
Mode
GigabitEthernet
Interface configuration
Global configuration
Global configuration
Global configuration
Privileged EXEC
Global configuration
Global configuration
Global configuration
13